Expanded AC Output
Includes 120V/20A and 115V/15A AC socket groups.











Convert 12V battery power into 115V AC modified sine wave output with 3000W continuous power. Maximum TANK Series output with expanded AC connections and a 110V direct-connect terminal.
Monitor connected-battery level, AC output power, input voltage and fault messages directly on the inverter display.
Confirm every connected device supports modified sine wave power and remains within the inverter ratings.
Includes 120V/20A and 115V/15A AC socket groups.
Each AC outlet has its own manual reset button acting as a built-in circuit breaker.
A line, neutral and ground terminal supports external AC output-system connection.
The inverter monitors battery voltage, internal temperature, output demand and short-circuit conditions.
Provides warning before shutdown.
Shuts down under low-input conditions.
Protects against excessive battery input voltage.
Model-specific information transcribed from the TANK Series user guide.
| Model | ERAYAK TANK3000 |
|---|---|
| Continuous Power | 3000W |
| Surge Power | 3000W |
| Input | 12V battery system |
| Nominal Output | 115V AC |
| Waveform | Modified sine wave |
| No-Load Draw | <0.45A DC |
| USB | 5V DC, 3.1A shared |
| AC Connections | 120V/20A and 115V/15A AC sockets |
| Remote On/Off | Included |
| Fuse | N/A in manual table |
| Cooling | Temperature-controlled fan |
| Protection | Low/high voltage, over-temperature, overload and short circuit |
| Weight | 7.2 lb / 3.3 kg |
High-current inverter performance depends on correct battery condition, cable connection, ventilation and load management.
Key checks before installation and operation.
No. The user guide specifies modified sine wave output. Confirm connected-equipment compatibility before use.
3000W is the continuous rating and 3000W is the surge rating published in the manual. Connected equipment must stay within both limits.
The LCD shows connected-battery level, AC output power in watts, battery input voltage and fault or warning messages.
The uploaded user guide lists both continuous power and surge power as 3000W. This PDP preserves the published value without assuming a higher surge rating.
Each AC outlet has a manual reset button acting as a built-in circuit breaker. After an outlet trips, unplug the connected device, wait a few seconds, then press that outlet’s reset button.
The inverter displays a fault indication and shuts down under the listed abnormal conditions. Follow the reset procedure in the user guide after correcting the cause.
No. The manual states that the product is not certified for life-support or medical devices.
For product information and support, use the contact address listed in the manual.